Shipbucket

Karle, sorry for the nuisance and saying that late, but i've not noticed it before; you might check if the tripod mast was that spaced at the top, because it may be not.

_________________
My Worklist
Sources and documentations are the most welcome.

-Koko Kyouwakoku (Republic of Koko)
-Koko's carrier-based aircrafts of WWII
-Koko Kaiun Yuso Kaisha - KoKaYu Line (Koko AU spinoff)
-Koko - Civil Aviation

It is the size that has been suggested earlier in this thread. If that don`t work then wich size will?

The source I used showed a more spaced set up, although it differs. Maybe the tripods are not as thick as they are supposed to be.

see here, Use it either do it like KHT says or experimenting to you find the correct type on you'r version of paint!

The larger ones on the fonts sheet is one size smaller than the ones I have used.

It's the official fonts for SB found in the parts sheet section of the forum, and at least I've used them without recieving any complaints. You'll be safe.

So why they look bad ? You sure you use KHT fonts ? Or maybe you have not set the anti-aliasing properly.

_________________

Nobody expects the Imperial Inquisition!

Does Paint.Net have anti-aliasing?

No idea, but your fonts have a look of .jpg trash so it's probably anti-aliasing fault. You can copy paste from KHT sheet.

_________________

Nobody expects the Imperial Inquisition!

Yes! Push the button in the red circle and you can easily shift between aliasing and anti-aliasing (BTW, when you use Paint.NET the font size for Arial closest to SB standards are 10 and 7)

_________________
Work in progress:
DD County Class PNS Babur (1982)(PAK)
FF Type 21 Class D182 PNS Babur (2000)(PAK)
All relevant Coat of Arms

Okay thanks.