Shipbucket

new update. see first post,

_________________
Drawings are credited with J.Scholtens
I ask of you to prove me wrong. Not say I am wrong, but prove it, because then I will have learned something new.
Shipbucket Wiki admin

update again! see the V1.3 changelog for the differences.

_________________
Drawings are credited with J.Scholtens
I ask of you to prove me wrong. Not say I am wrong, but prove it, because then I will have learned something new.
Shipbucket Wiki admin

Have you artwork for the LW-01 radar antenna? What I really need is a flat pattern of the LW-01 antenna, to photo-etch it for a 1/700 model ship.

Nice Ace, nice. I have already used a few parts for the redraw of my AU Anghellis cruiser. (Which I promise won't make your eyes bleed this time )

Just asking, is it okay if I redraw the Gatekeeper? This may be sort of nitpicking on my behalf, and I don't mean to criticise your very nice work, but this one just doesn't look right. It's barely even noticable on most colour schemes, unfortunatly. (No shit since everything about it is small, but still.)

_________________
You can call me Andy.

well, gatekeeper is what it is, just an glassed hole in the I-mast in this case. I would love it though if you could draw this version: http://www.thalesgroup.com/gatekeeper/
the sizes and all are in the datasheet pdf

_________________
Drawings are credited with J.Scholtens
I ask of you to prove me wrong. Not say I am wrong, but prove it, because then I will have learned something new.
Shipbucket Wiki admin

Ah yes, now I see why it looks like that. This one is the I-mast intergrated version, correct?

I'll draw the standalone version, most likely it'll be done in 3 mins.

_________________
You can call me Andy.

I drawed the version on Thales' website. Uh, I still think I haven't done it right but there's no other way to draw it other then to go outside of SB scale. It's the one on the far right.


The other three are three different views based upon this (and other) reference image, which appearently shows an alternative lightweight gatekeeper (No IR cooling?) on a mount with two wind speed meters, three antennas, and two bow lights. My guess is that this is for patrol boats, coast guard etc. I can see that in order to maintain it one can remove the one of three entire gatekeeper assemblies, and take it to a workshop or something.



Additional information on the website I found it (Dutch, but at least Ace can read it ): http://www.mechatronicamagazine.nl/nieu ... ixels.html

_________________
You can call me Andy.

did an small update again, mostly for the new LW-08 that is correctly sized. for the other changes, look at the changelog.

_________________
Drawings are credited with J.Scholtens
I ask of you to prove me wrong. Not say I am wrong, but prove it, because then I will have learned something new.
Shipbucket Wiki admin

?In what way was the previous LW-08 too large? The Stabilisation mechanism was slightly exxagerated, but that was for detail's sake. The antenna should have been corectly sized?

_________________
Would you please not eat my gun...

sigh. I expected something like this.
it was redrawn by mitch, controlled by alvama and recommended by golly. I myself would rather keep the old one (just for the sake of parts standardisation, if nothing else) still, against all this might, I had no other choice then to swap them.......
it was 4 pixels too wide, 3 pixels too wide or something like that....

_________________
Drawings are credited with J.Scholtens
I ask of you to prove me wrong. Not say I am wrong, but prove it, because then I will have learned something new.
Shipbucket Wiki admin