yeah, the cross sections shown on the plans do not match your drawing at all. the hangar deck level would be as wide as the hull, while you have mooring points next to that deck and an overhanging flight deck.
also:
- the gun sponsons will need supports.
- the railings on the gallery deck would be shaped somewhat different, I think.
- the portholes in the side of the hangar deck level do not match the deck levels of the section shown in the oringal plans
- you have portholes and air intakes in the superstructure section dedicated to the uptake.
- I doubt the flaglines would go towards the gun platforms
- the radars look awfully close to each other.
- I think your crane does not have the size shown on the plans
- there are no liferafts or resque equipment on this ship
- you have multiple doors floating 2m above the deck.
- I have doubts about the bridge windows looking like that.
- the top view shows that the platforms extroding from the bridge are not as square as you made them look. there are bends and curves in them, that should be shown and shaded. the same goes for your entire flight deck btw
- you have made verious openings in the side of the hangar deck level. find out what they are for and where they should be, because now they look to be random.
- it is common when drawing carriers to draw top views and both sides of the ship
this because unlike most other ships, a carrier is defined a lot by its deck and is asymetrical.