Moderator: Community Manager
[Post Reply] [*]  Page 13 of 19  [ 186 posts ]  Go to page « 111 12 13 14 1519 »
Author Message
swin_lad
Post subject: Re: Some Desigs for my AUPosted: May 17th, 2014, 5:43 am
Offline
User avatar
Posts: 312
Joined: December 10th, 2010, 2:05 pm
Location: Swindon Town FC, From the West Country
I remember an artists impression for the FAA being done...

_________________
Nick

@ashwellkennedy


Top
[Profile] [Quote]
shippy2013
Post subject: Re: Some Desigs for my AUPosted: May 17th, 2014, 3:47 pm
Offline
User avatar
Posts: 658
Joined: March 26th, 2013, 7:44 pm
Location: Nottingham. United Kingdom
Moving on from air assets and back to the Navy. I've begun to rewrite some of my AU's Carrier history and now instead of the Ocean class CV's I have gone for the Ocean Class vessels being LPH's but fitted with a Ski Jump to enable Harriers to be Launched and New Cromer wont be taking Frances Place on the CVF project instead back in 1988 New Cromer was working on it's own Carrier design with the Help of the French and the US for a Nuclear Powered CVN. about the size of the CDG. I remembered I had drawn this a while back and found it while going through my files, I did a bit of tweeking and here's the back story.

in 1987 the Navy was looking for new Carriers to replace it's Centaur class carriers built in the late 1960's. after a number of years of searching for replacement aircraft for its hard worked and clapped out Buccaneer's and Vixen's the size of the Centaurs proved a severe limiting factor, so in 1988 plans were drawn up with France and the US to design and built two new carriers. powered by reactors based on the British submarine reactors but boasting much higher outputs. problems and delays meant the ships would not be ready anytime soon and as the Buccaneer's and Vixen's were worn out the two Centaur class carriers would be re built as STOVL carriers to operate the Harrier until the new carriers were ready hopefully by 1999.

further delays to the project and a serious fire on board the Centaur Class Victoria leading to its decommissioning in 1991 led to only Cromer being rebuilt. at the time the Navy was also looking for two LPH class ships and had seen preliminary design's for Britain's HMS Ocean, New Cromer ordered 2 ships to a slightly modified design able to operate the Harrier as these would have to fill in for the two new CVN's till they were ready. these to ran into delays and would not join the fleet till 2002 further design problems and delays also hit the CVN's and a service date for these was still no were to be seen steel was finally cut in 1999, all this meant the Centaur class Cromer would have to soldier on for longer.

The Centaur Class Cromer re entered service in 1994 to it's new STOVL design and would be New Cromer's sole carrier till 2002 when the two Oceanic Class CV/LPH became operational. by which time the Centaur Class Cromer was suffering from regular machinery failures and was deemed by some of her crew dangerous to operate and a serious accident waiting to happen.

in 2002 the CV/LPH's were ready and the very worn out NCNS Cromer was retired the two CV/LPH's taking over the Harrier operations until the new CVN's and there as yet undecided aircraft would be ready. in 1999 the new and then being tested Boeing McDonald F/A18 E and F Hornet was chosen as the aircraft of choice for the navy and an order was placed. The First Carrier finally entered service in 2006 and was followed in 2008 by the second. in the meantime Pilots from New Cromer had gone over to the US on training to fly the F/A18 and as well as training in the US had seen deployments on US Carrier's to better there skills. the F/A18G was ordered in 2012 and these should be delivered in 2015. the carriers will operate with an air wing of 12xF/A18E, 12xF/A18F, 2 or 3xF/A18G, 2xCV-22 HC.3, 2xKCV-22 KC.1, 3xECV-22 AEW.1, 4xEH101 HAS.3 and 4xEH101 SAR.3

The F/A18's will be built locally form Kits supplied by Boeing but will be powered by locally built licenced versions of the EJ220 engine which has 27,000lb thrust over the GE F414's 22,000lb.

apologies for image size but i'm still tinkering...
[ img ]


Last edited by shippy2013 on May 19th, 2014, 9:54 am, edited 1 time in total.

Top
[Profile] [Quote]
odysseus1980
Post subject: Re: Some Desigs for my AUPosted: May 18th, 2014, 5:42 am
Offline
User avatar
Posts: 3607
Joined: November 8th, 2010, 8:53 am
Location: Athens,Hellenic Kingdom
Contact: Website
An CV with a British touch, side lines of front hull reminds something from Majestic Class. Nice work!


Top
[Profile] [Quote]
LEUT_East
Post subject: Re: Some Desigs for my AUPosted: May 18th, 2014, 5:46 am
Offline
User avatar
Posts: 923
Joined: December 29th, 2011, 7:27 am
Location: Queensland, Australia
Lovely piece of work Sir.

_________________
There is no "I" in TEAM but there is a ME

[ img ]
______________________
Current Worklist:
Redrawing my entire AU after a long absence from Shipbucket


Top
[Profile] [Quote]
shippy2013
Post subject: Re: Some Desigs for my AUPosted: May 20th, 2014, 7:29 pm
Offline
User avatar
Posts: 658
Joined: March 26th, 2013, 7:44 pm
Location: Nottingham. United Kingdom
in my AU i'm looking for a replacement for the Ex Leander Class frigates.

[ img ]

[ img ]

I've tinkered with The Bae Corvette design drawn by Mconrads, Alvama and Van Owen to hopefully come up with something viable and not to costly. 4 ships will be aqquired


Top
[Profile] [Quote]
Blackbuck
Post subject: Re: Some Desigs for my AUPosted: May 20th, 2014, 8:36 pm
Offline
Posts: 2743
Joined: July 27th, 2010, 9:15 am
Location: Birmingham, United Kingdom
In all honesty. I'd probably not ship ASTER on something like that corvette. Sea Ceptor or indeed Sea Wolf until it is supplanted would probably fit better IMO.

_________________
AU Projects: | Banbha et al. | New England: The Divided States
Blood and Fire


Top
[Profile] [Quote]
shippy2013
Post subject: Re: Some Desigs for my AUPosted: May 20th, 2014, 9:13 pm
Offline
User avatar
Posts: 658
Joined: March 26th, 2013, 7:44 pm
Location: Nottingham. United Kingdom
I wanted cam quad packs in that a 43 but couldn't find a drawing. Could artisan work or do I need another director


Top
[Profile] [Quote]
TimothyC
Post subject: Re: Some Desigs for my AUPosted: May 21st, 2014, 3:26 am
Offline
User avatar
Posts: 3765
Joined: July 27th, 2010, 3:06 am
Contact: Website
Shippy,

I'm sorry for not remembering I had this saved on my hard drive earlier (it's amazing what having to do a fast backup of everything will do), but here is an image that includes the underwater hull of the River class, and they have a differently shaped bow from what you've drawn.

_________________
𝐌𝐀𝐓𝐇𝐍𝐄𝐓- 𝑻𝒐 𝑪𝒐𝒈𝒊𝒕𝒂𝒕𝒆 𝒂𝒏𝒅 𝒕𝒐 𝑺𝒐𝒍𝒗𝒆


Top
[Profile] [Quote]
shippy2013
Post subject: Re: Some Desigs for my AUPosted: May 21st, 2014, 6:47 am
Offline
User avatar
Posts: 658
Joined: March 26th, 2013, 7:44 pm
Location: Nottingham. United Kingdom
TimothyC wrote:
Shippy,

I'm sorry for not remembering I had this saved on my hard drive earlier (it's amazing what having to do a fast backup of everything will do), but here is an image that includes the underwater hull of the River class, and they have a differently shaped bow from what you've drawn.
not sure who actually drew the underwater hull I have it was there when I got the drawing but know you've given me this ill draw a new one thanks...


Top
[Profile] [Quote]
Blackbuck
Post subject: Re: Some Desigs for my AUPosted: May 21st, 2014, 7:28 am
Offline
Posts: 2743
Joined: July 27th, 2010, 9:15 am
Location: Birmingham, United Kingdom
shippy2013 wrote:
I wanted cam quad packs in that a 43 but couldn't find a drawing. Could artisan work or do I need another director
As far as I'm aware all you should nee would be Artisan. Sea Ceptor is an active missile so wouldn't need illumination.

_________________
AU Projects: | Banbha et al. | New England: The Divided States
Blood and Fire


Top
[Profile] [Quote]
Display: Sort by: Direction:
[Post Reply]  Page 13 of 19  [ 186 posts ]  Return to “Personal Designs” | Go to page « 111 12 13 14 1519 »

Jump to: 

Who is online

Users browsing this forum: Bing [Bot] and 2 guests


The team | Delete all board cookies | All times are UTC


cron
Powered by phpBB® Forum Software © phpBB Limited
[ GZIP: Off ]