I found out that the gun placing in you'r drawing was a bit messy, and since this ship was to be build on what have bean learned over two World wars. I changed around the gun layout. There are many reason and many advantage of this. here's my list (note I haven't removed any guns):
- main guns as it is.
- Secondary I have pulled closer to the main guns. many reason, but main reason is that I was afraid that mounting the secondary to far out would give a weakens in the hull section, and strain on the bulkheads and keel.
- third armament. I moved the a bit around, mounted directly to the main deck, so the weight of those guns get as low as possible. And as you can see a have mounted them in a sort of a ring. So this will be the outer ring armored box.
- fourth armament. I moved them in the same way as with the third armament. but also make a opening and have them as low as possible. This is the inner ring armored box.
* Note that all gun are placed so the should get as good firing arch as possible, without damaging the balance of the ship. If it was me I would remove the third armament and move the secondary to where the aft and forward third armament is placed and increase the fourth armament.
* And as you can see, this give the flight deck a clear path above and between guns. With a lot of space.
* This layout give me the Normal armored hull and deck but add the twin (ring) armored box. (this would save some weight). Note this would make the ship better armored than Montana
- Large flight deck capable to handle two launch and recover simultaneously, twin large Hangar with workshop forward of the flight deck, two small hangar with workshop aft of the flight deck.
- conning-tower partially build in to superstructure.
for some reason I want a South Dakota/Iowa mast.