Shipbucket
http://67.205.157.234/forums/

Erik Hägg, light cruiser suggestion 1916
http://67.205.157.234/forums/viewtopic.php?f=13&t=9568
Page 1 of 1

Author:  Psilander [ May 29th, 2019, 4:09 pm ]
Post subject:  Erik Hägg, light cruiser suggestion 1916

In march 1916 commander Erik Hägg (CO of HSwMS Oscar II) posted a suggestion for a light scout cruiser for the RSWN in the Royal Swedish Naval Society Gazette (Tidskrift i Sjöväsende). The article can be found here on page 222 (57).

Length: 15m
Beam: 12,8
Draught: 4,3m
Dpl: 3000t
Speed 30kts
Cost: 6 million sek

Arnament:
4x1 15,2 cm guns
5x1 7,5cm guns
2x 45cm underwater torpedotube

[ img ]

Author:  eswube [ May 29th, 2019, 6:50 pm ]
Post subject:  Re: Erik Hägg, light cruiser suggestion 1916

Interesting.
But I'm afraid that rudder and screws have been accidentialy cut off, and there are stray pixels between antenna wires and near the caption.

Author:  Krakatoa [ May 30th, 2019, 2:36 am ]
Post subject:  Re: Erik Hägg, light cruiser suggestion 1916

Arnament:
4x1 15,2 cm guns

I see only three 6" mountings.

Author:  gral [ May 30th, 2019, 11:02 am ]
Post subject:  Re: Erik Hägg, light cruiser suggestion 1916

I'm assuming there are two side-by-side bow mounts, as on the German light cruisers of the period.

Author:  Psilander [ June 1st, 2019, 9:19 am ]
Post subject:  Re: Erik Hägg, light cruiser suggestion 1916

Drawing updated

I do also submit the original drawing from Tidskrift i Sjöväsende march edition 1916.

[ img ]

Author:  acelanceloet [ June 1st, 2019, 10:10 am ]
Post subject:  Re: Erik Hägg, light cruiser suggestion 1916

Where's the propulsion though?

Author:  Hood [ June 1st, 2019, 10:12 am ]
Post subject:  Re: Erik Hägg, light cruiser suggestion 1916

Certainly an interesting design, thanks for sharing it here and good to see you drawing again.

The stern arrangement is odd, maybe the propellers are meant to be on the end of that odd skeg?

Author:  eltf177 [ June 2nd, 2019, 6:10 pm ]
Post subject:  Re: Erik Hägg, light cruiser suggestion 1916

Curious to know if there's any information on what the armor scheme was to be (if any armor at all)...

Author:  Miklania [ June 6th, 2019, 9:25 pm ]
Post subject:  Re: Erik Hägg, light cruiser suggestion 1916

The placement of the skeg is odd, it may be to get the props deeper for more efficiency, but personally I think it's on the centerline and there to protect the rudder from grounding. That seems more likely that pushing the props down for a country that operates in treacherously shallow waters. Prop shafts probably aren't shown, for some reason or another.

Author:  heuhen [ June 7th, 2019, 12:17 am ]
Post subject:  Re: Erik Hägg, light cruiser suggestion 1916

that skeg is to protect the ruder from ice that is being pushed under the hull.

She is most likely a twin screw ship, just as many other Swedish navy ships of that time

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/